15318 Autoloader ALE: Manual bypass loading is not supported on this machine. Trendsetter_400/800_Auto This error indicates that your machine is an E-type machine, and manual bypass loading is not supported. If this error occurs on something other than an E-type machine, call Creo Service. This error is reported when the workstation tries to launch a manual-bypass job on an E-type machine. Manual bypass loading and unloading is not supported on these low-cost E-type machines. A manual load or manual unload was requested from the workstation, or through the diagnostic "mload" or "munload" commands. ../commands/mload.xmlCommand: mload ../commands/munload.xmlCommand: munload ../commands/config.xmlCommand: config ../nvs/config_cfg_type.xmlNVS: config type ..\..\ShowAllErrors.htmFirmware 0 Error Index ..\..\ShowAllCommands.htmFirmware 0 Command Index ..\..\ShowAllNVS.htmFirmware 0 NVS Index Updated: Wed Jul 16 19:33:01 2008 PST